Sangean WR-2CL Manual Del Usuario página 12

Monitor radio alarm station
Note: remote control unit is not applicable for this operation.
1. Ensure the radio is switched off.
2. Long press the M1 button, until display shows radio frequency.
Hold down another 3 seconds, display will flash radio frequency,
hold down another 3 seconds to cancel the set radio station.
3. Display will show "
Snooze function
1. Whilst an alarm is sounding, pressing any button (except the
On/Off or Light button) will activate the snooze function.
The radio or buzzer alarm will be silenced for 5 minutes.
2. The display will flash both the snooze symbol
symbol. The snooze function can be repeated during the period
that the alarms are active .
Cancel alarm setting
Cancel the alarm setting can be done both radio is on or off.
1. When radio is off, press and release Display button,
display alarm icon will flash. (when radio is on, press Display
button to alarm status)
2. Long press SET button until both alarm icon and time digits flash.
3. Press and release SELECT button until display flashes
4. Press SET button again to cancel alarm status.
Display alarm icon will disappear after flashing a couple
of seconds.
11
", when no radio station is set.
and the alarm
.