Publicidad
OPERATION
WARNING:
Disconnect the tool from the air supply before
removing fasteners or clearing a jammed fastener.
Failure to do so could result in serious personal
injury.
CLEARING A JAMMED FASTENER
See Figure 11.
If a fastener becomes jammed in the tool, disconnect the
air hose and keep the tool pointed away from you while
clearing the jam.
Disconnect the tool from the air supply.
Remove fasteners from the magazine.
Using a 3 mm hex wrench, remove the two bolts and front
plate.
Remove the jammed fastener. Make sure the nail track is
free of bent fasteners or fragments.
If the driver blade prevents removal of bent fasteners or
fragments, use a small flat-blade screwdriver to gently tap
the driver blade backwards past the jammed fastener.
Remove the jammed fastener and make sure the nail track
is free of bent fasteners or fragments.
Reinstall the front plate and bolts, making sure they are
secure.
Reconnect the tool to the air supply.
Reload the tool with fasteners.
SCREWdRIVER
6
BOLTS
FRONT
PLATE
Fig.
Publicidad
