Onvis SMS2 Manual Del Usuario página 2

QUICK START GUIDE
1. Insert the included 2 AAA alkaline batteries and close the cover.
EN
2. Make sure the Bluetooth of your iOS device is on.
3. Use the Home app, or download the free Onvis Home App and open it.
4. Tap the 'Add accessory' button, and scan the QR code on the SMS2 to add the accessory to your
Apple Home system.
5. Name the SMS2 smart motion sensor. Assign it to a room.
6. Set up an Apple Home hub (HomePod Mini and Apple TV4K2021 or later with Thread) to enable
Thread+Bluetooth connection, remote control, notification and automation.
7. For troubleshooting visit:
Note:
-When QR code scanning is NOT applicable, you may manually input the SETUP code printed on the
cover page.
-If the app prompts "Couldn't add Onvis-XXXXXX", please reset and re-add the device. Please keep
the QR code for future use.
-The use of a HomeKit-enable accessory needs the follow permissions:
a. Settings>iCloud>iCloud Drive>Turn On
b. Settings>iCloud>Keychain>Turn On
c. Settings>Privacy>HomeKit>Onvis Home>Turn On
Thread and Apple Home Hub Setting
It is recommended to use Thread for stable connection and low latency. An Apple device as Home
hub (Home Pod / Apple TV4K2021 or later) is necessary to enable Thread connection, remote control,
notification and automation. After setting up via Bluetooth, it will take several minutes for SMS2 to join
your Thread network.
You may find the instruction here: http://www.onvistech.com/page-1718.html, or on the Apple website:
https://support.apple.com/en-us/HT207057.
http://www.onvistech.com/page-1717.html