Publicidad
Idiomas disponibles
Idiomas disponibles
ventilation is sufficient so this concentration does not happen again.
Petrol and oil are extremely flammable and explosive under certain conditions. Do
not smoke and keep flames, sparks or heat sources away from the machine.
Do not smoke while transporting fuel, when you fill out the deposit or when you
are working.
Do not refuel fuel in locations where there is the presence of open flames, sparks or heat
sources. Fill the tank always in well-ventilated areas and with the motor stopped. Do not
overflow fuel when trying to overfill the fuel tank. In the event of a fuel leak, be sure to clean
these leaks completely before starting, move the machine away from the spillage area and avoid
any source of ignition until all vapours are gone. Add fuel before starting the machine.
Never remove the cap of the fuel tank while the engine is running or when the machine is hot.
Do not refuel in enclosed spaces, in poorly ventilated areas or near flames.
Make sure the cap of the fuel is tightly and correctly closed while you are using the machine.
Make sure to correctly and tightly close the cap on the fuel after refilling.
Do not use fuel that it has been stored for longer than 2 months.
2.5 C
A
U
ARE
ND
SE
The chipper is only designed to shred pieces of wood. It is prohibited to shred any other
material ( for example metal, stones, plastics and any other material). If you want to
shred roots, remove the sand, mud or other residues before shredding. Any other use of the
shredder not described here, annuls the warranty responsibility of the manufacturer.
Check that all the safety devices are installed and in good condition.
Remember that the machine operator is responsible for the dangers and accidents caused to
other people or things. The manufacturer will not be in any way liable for damages caused by
improper or incorrect use of this machine.
The cutting tool is very sharp. Not following the instructions may cause severe damage.
Keep this machine maintained and in proper condition. Check that the moving parts are not
misaligned or locked, that there are no broken parts or other conditions that may affect the
operation of this machine. Whenever this machine is damaged, repair it before use. Many
accidents are caused by poorly maintained machines.
Check:
-
The machine completely and look for loose and damage parts (screws, nuts, etc.);
-
Engine oil level;
-
Damaged and /or defective welded parts.
Make sure that the machine has passed the adequate maintenance controls. All damage caused
by the use of defective, worn out or non-original parts, annuls the warranty responsibility of the
manufacturer.
O
T
M
F
HIS
ACHINE
４
Publicidad
