Publicidad
Idiomas disponibles
Idiomas disponibles
8.MAINTENANCE
WARNING: Turn OFF the machine, allow all moving parts to come to a complete stop, and
disconnect the spark plug wire before moving the machine, emptying the bag, unclogging the
inlets or outlets, filling the gas tank, or performing maintenance and repairs.
8.1.V
I
ISUAL
NSPECTION
Before and after every use of the wood chipper, it is recommended that the following inspection
process take place. This is quick and easy, and ensures your safety as well as the machine's
performance.
1. Check the Hopper, Chute, Funnel and guards for cracks, holes and loose bolts;
2. Check the frame and base of the machine for cracks or damage;
3. Check all the bolts and screws to ensure tightness;
4. Wear gloves, check the blades are not cracked or loose;
5. Check the engine oil level using a dipstick.
8.2.C
LEANING
It is strongly recommended to clean the machine after every use. After use, turn off the machine,
allow the engine to cool fully, and remove the spark plug.
Brush off or vacuum excess wood chippings and wipe off the remaining dust from the exterior of
the machine with a dry cloth. Do not expose the machine to water or attempt to clean by
pouring water on/into it. Remove any chips or debris from the hopper and the discharge chute.
It is increasingly difficult to clean this machine the longer you let it sit unclean. The machine's
performance will naturally decrease if it is not properly cared for.
To clean the engine from built-up resins, you may need to purchase an engine cleaner. These are
available at most auto-parts stores or online.
8.3.M
AINTENANCE
8.3.1.SPARK PLUG
After every 50 hours of running the spark plug should be removed. Check the colour of the
deposits on the end of the spark plug it should be a "Tan" colour. Remove all deposits using a
stiff brush a brass wire brush is ideal. Check the spark plug gap (Pic.21) and adjust if required.
The correct gap should be 0.7 to 0.8mm.
O
E
F
NGINE
１７
Publicidad
