ExecutiveSafe CS-2 Manual De Usuario página 3

PLEASE READ THE MANUAL ENTIRELY BEFORE START USING THE SAFE
Bolt-down instructions
To help provide maximum security, bolt down is strongly recommended.
1. Select a suitable and convenient location for your safe. Set the safe in place
and use the holes provided in the bottom and /or back of the safe to mark the
location of the holes to be drilled in the floor or wall. If bolting to a wall, please ensure
that the safe is resting on a supporting surface, i.e. floor, table, shelf, bracket.
2. Move the safe away and drill holes of the appropriate diameter and depth
for the type of hardware being used and the mounting surface
3. Place the safe back over the holes and install the fasteners as required.
Using the override key to open the safe
Remove the override key cover, located between the knob and the keypad, see Fig. 1, then use the
override key and turn it counter clockwise. Turn the knob clockwise to open the door. To finish
the operation, turn the key clockwise and remove it.
Fig.1
NOTE: DO NOT STORE THE OVERRIDE KEY IN YOUR SAFE!
Please secure your override keys in a safe place. If the override
keys are lost or damaged, contact your local ExecutiveSafe office.
Battery Installation
Four alkaline AA batteries (included) are required.
NOTE: Non-alkaline or rechargeable batteries ARE NOT RECOMMENDED.
To install the batteries, remove the battery cover located on
the inside back side of the door, by sliding it to the right. See Fig. 2. Insert the four
batteries as indicated. Insert back the battery cover.
NOTE: Batteries should be replaced when both the red and green lights come on at the same
time when you enter your combination or the red light LOW BATT indicator is on.
Fig.2