Publicidad
Idiomas disponibles
Idiomas disponibles
3. Place tabletop on a smooth, non-marring surface
with top side facing down.
4. Center leg assembly on tabletop. Attach using
16 wood screws and drill with 10 mm drill bit or
Phillips drill bit. (See Figure 2)
5. Insert threaded end of leveling feet or casters into
threaded holes on bottom of legs. Turn clockwise to
tighten. (See Figures 3-4)
NOTE: If using casters, ensure they are in lock
position before setting table upright.
6. Carefully set table upright and check that all screws
are tight.
NOTE: If using leveling feet, adjust as necessary
to ensure stability.
PAGE 2 OF 6
ASSEMBLY CONTINUED
Figure 2
Figure 3
1-800-295-5510
uline.com
Figure 4
1022 IH-10199
Publicidad
