GreenWorks Tools 2103207 Manual De Utilización página 6

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
PROBLEM
String will not advance when using
the bump-feed head.
Grass wraps around shaft housing
and string head.
Motor fails to start when switch trigger
is depressed.
English (original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level
Battery is not secure.
Battery is not charged.
Shaft not connected completely
SOLUTION
Lubricate with silicone spray.
Install more string. Refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in
this manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make
sure the latch on bottom of the battery
pack snaps into place.
Charge the battery pack according
to the instructions included with your
model.
Make sure lower shaft is fully seated
in shaft coupler on upper shaft and
secure shaft coupler.
5