Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8.3
ADJUST THE 2-SPEED GEARBOX (HI-LO)
The machine has a 2-speed gearbox designed for
drilling or driving at LO (1) or HI (2) speeds. A slide
switch is on top of the machine.
1.
When you use the machine in the LO (1) speed,
the speed decreases and the machine has more
power and torque.
2.
When you use the machine in the HI (2) speed,
the speed increases and the machine has less
power and torque.
Use LO (1) speed for high power and torque
applications and HI (2) speed for fast drilling or
driving applications.
8.4
SELECT THE MODE
To change the operation mode, adjust the mode
selection ring to the correct position.
The machine is used for three functions: driver (a), drill
(b) and hammer drill (c).
Torque can not be adjusted until the driver (a) mode
starts.
A. The direction to decrease torque.
English (Original Instructions)
WARNING
(b)
(a)
(c)
NOTE
B. The direction to increase torque.
When hammer drilling, do not apply too much
pressure.
8.5
ADJUST THE TORQUE
The proper setting depends on the job and the type of
bit, fastener, and material you will be using. In general,
use greater torque for larger screws. If the torque is
too high, the screws may be damaged or broken.
1.
Turn the clutch clockwise to decrease the torque.
2.
Turn the clutch counter-clockwise to increase the
torque.
Torque adjustment is only active under driver mode.
8.6
ADJUST THE FORWARD/REVERSE
SWITCH
The machine has the forward/reverse switch above the
switch trigger to chang the direction of the bit.
1.
When the forward/reverse switch is on the left
side of the trigger, the bit direction is forward
(tightening).
2.
When the forward/reverse switch is on the right
side of the trigger, the bit direction is reversed
(loosening).
10
NOTE
NOTE
Publicidad
