Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Remove the bit.
WARNING
Be prepared for binding at bit breakthrough. When
these situations occur, drill has a tendency to grab
and kick opposite to the direction of rotation and
could cause loss of control when breaking through
material. If not prepared, this loss of control can
result in possible serious injury.
7.6
INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1.
Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
3.
When you hear a click, the battery pack is
installed.
7.7
REMOVE THE BATTERY PACK
English (Original Instructions)
9
1.
Push and hold the battery release button.
2.
Remove the battery pack from the machine.
8
OPERATION
WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
8.1
START THE MACHINE
2
The machine can not work until the forward / reverse
switch is pushed fully to the left or right. Do not
operate the machine at low speeds for extended
periods of time.
1.
Push the forward / reverse switch to left or right.
2.
Pull the trigger to turn the machine ON.
Variable speed
The machine has a variable speed trigger that delivers
higher speed with increased trigger pressure and lower
speed with decreased trigger pressure.
8.2
STOP THE MACHINE
1.
Release the trigger to turn the machine OFF.
WARNING
Release the trigger and allow the machine to come
to a complete stop.
1
NOTE
EN
Publicidad
