Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3.
Place the hooks over the mounting ribs, making
sure the hooks are positioned in the slots as
shown.
4.
Turn the auxiliary handle grip clockwise to tighten
and counterclockwise to loosen.
Make sure the handle is secure before beginning
operation.
7.4
INSTALL THE BIT
1.
Push forward / reverse switch in "neutral" position
to lock the trigger.
2.
Turn the chuck counter-clockwise to open.
English (Original Instructions)
CAUTION
3.
Tilt the machine upwards to keep the bit from
falling out
4.
Put the drill bit into the opening of the chuck.
5.
Ensure the bit is secured, then turn the ratcheting
chuck clock-wise to safely secure in the drill bit.
Do not use a wrench to tighten or loosen the chuck.
Put the bit straight into the chuck jaws. Do not put
the bit into the chuck jaws at an angle then tighten.
7.5
REMOVE THE BIT
1.
Push forward / reverse switch in "neutral" position
to lock the trigger.
2.
Turn the chuck counter-clockwise to open.
8
NOTE
WARNING
Publicidad
