Publicidad
Idiomas disponibles
Idiomas disponibles
BM 1609929F51 10/03
10/29/03
SELECTING SANDING DISC
Sanding discs are made of extremely hard
and sharp aluminum oxide grits, phenol-
resin bonded to a sturdy fiber backing for
fast heavy-duty service and long life. The
discs vary as to size and spacing of the
abrasive grits. OPEN COAT (type H) — used
for soft materials and on paint or varnish.
CLOSED COAT (type K) —used for metal,
hardwood, stone, marble and other
materials.
Sanding discs range in grit from 16 (very
coarse) to 180 (very fine). To obtain best
results, select sanding discs carefully. Many
SANDING TIPS
For best results, tilt the Disc Sander at a 10°
to 15° angle while sanding so that only about
1" of the surface around the edge of the disc
contacts the work.
If the disc (accessory) is held
WARNING
!
flat or the back edge of the
disc comes in contact with the work, a
violent thrust to the side may result.
If sander is tilted too much, sanding action
will be too great and a rough cut surface or
gouging and snagging will result.
Guide the Disc Sander with crosswise
SANDING WOOD
When sanding wood the direction of the disc
motion at the contact point should parallel
the grain as much as possible. The rapid cut
of discs and the swirl type scratch pattern
they occasionally create generally prohibit
their use for producing the final finish.
Scratches and circular marks are usually the
result of using too coarse a grit. When
changing to a finer grit, move across the
sanding lines that were made by a previous
coarser disc.
8:05 AM
Page 10
Sanding Operations
jobs require the use of several grit sizes and
at times both "open coat and closed coat"
discs are required to get the job done faster.
See chart for application examples.
Operation: Refinishing painted wood or metal surfaces.
REMARKS
To remove paint and to smooth
surface irregularities.
To smooth
the rough sanding.
To remove scratches left by
previous discs.
To smooth surfaces for painting,
polishing or waxing.
strokes. Be careful not to hold the sander in
one spot too long. Do not use a circular
motion, as this makes swirl marks. Test
before use on scrap stock.
Do not force or apply pressure when
sanding. Use only the weight of the tool for
pressure. Excess pressure actually slows the
tool down. If faster stock removal is desired,
change to a coarser grit disc.
Remove gummy paint from metal with an
"open coat" disc. Sand until sparks start to
appear, then stop and change to a "closed
coat" disc to remove any remaining paint.
SANDING METAL
When sanding automobiles or appliances,
wipe the metal clean with a non-flammable
solvent or commercial cleaner to remove all
wax and grease. By doing this first, the
sanding discs will sand better and last
longer.
For heavy duty work, use a coarse grit disc
first. Follow-up with a medium grit to remove
scratches. To produce smooth finish, use
fine grit disc.
-10-
GRIT
Coarse
16-24-30
Medium
36-50-80
Fine
100-120
Very Fine
150-180
Publicidad
