Beper P102ROB200 Manual De Instrucciones página 10

Electrical Meat Grinder with Tomato Juicer Use instructions
Before using the product for the first time, please clean each component
following the instructions as indicated in the specific paragraph.
The use of the reverse function that can be operated with the REVERSE
button should not be used while the product is operating, always wait for the
product to stop.
Description Fig. A
1. Hopper plate
2. Fasten button
3. ON/OFF/REVERSE button
4. Main unit
5. Head connector
6. Food pusher
7. Head
8. Snake
9. Cutting plate fine
10. Fixing ring
11. Cutting plate coarse
12. Cutting plate medium
13. Cutting blade
14. Sausage attachment
15. Kibbe attachment (cone and adaptor)
16. Splash guard
17. Fixing screw
18. Filter holder for tomato juicer
19. Tomato juicer filter
20. Tomato juicer snake
Assembling Fig.B
Press the fasten button hold the head and insert it into the inlet turning on the right.
Move the head anticlockwise so that the head being fastened tightly.
Place the snake into the head, long end first, and turn to feed the screw slightly until it is set into the motor
housing.
Place the cutting blade onto the snake shaft with the blade facing the front as illustrated. If it is not fitted properly,
meat will not be grinded.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the slot.
Press the centre of the cutting plate with one finger then screw the fixing ring tight with another hand. Do not
over tighten.
Place the hopper plate on the head and fix it into position.
Locate the unit on a flat and stable place.
Attention: the air outlet placed on the bottom of the motor housing should be kept free and not
blocked
Mincing meat
Cut all foods into pieces (approximate size 2x2x6 cm) so that they fit easily into the hopper opening. It is recom-
mended to use nerveless, boneless and fatless meat.
Plug the unit and switch the ON button.
Put the food into the hopper plate. To make the mincing easier slightly press the food with the food pusher.
Never use hands or other utensils to press the foods.
After each use switch off the appliance using the ON/OFF button. Then unplug it from power supply.
Remove any remaining meat and clean the product and its components immediately.
10