Installing Or Removing Leg And Footrest Riggings; Elevating Legrest Operation; Recliner Operation - Medline Excel 2000 Guía Para El Usuario

Installing / Removing The Swing-Away Legrest / Footrest Riggings
To Install The Riggings:
1. Hold the legrest rigging to the side of the wheelchair.
2. Install the legrest assembly hinge plates onto the hinge pins of the frame (Fig 15/16).
3. Push the legrest rigging to the front until it locks securely into place. (Fig 17).
To Swing-Away / Remove The Legrest Assembly:
1. Fold the footplate up to the vertical position.
2. Release the legrest lock by pushing on the legrest lever (Fig. 18/19).
3. Swing the legrest outward and to the side (Fig. 20).
Hinge
Pins
Fig.15
4. To remove the legrest, lift up on the assembly to remove the legrest off the hinge pins.
Fig.18
Elevating The Legrest (For Models Equipped With Legrest)
1. To elevate the legrest assembly, simply lift up on the legrest assembly by the footplate to the desired height or position.
2. Release the legrest and it will automatically lock in place due to the ratchet rod.
3. To lower the legrest assembly, hold onto it by the footplate and push out on the legrest lever.
4. Slowly lower the legrest until the desired position is reached.
Recliner Operation (Excel Recliner Models Only)
WARNINGS:
• ALWAYS make sure the wheelchair is stable BEFORE using the recliner.
• Anti-tippers MUST be attached at all times. Ensure both anti-tippers are adjusted to the same height.
• Ensure the stabilizer bar is attached and secured BEFORE using the Excel Recliner.
• Use good body mechanics! Be prepared to support the weight of the occupant when assisting with reclining / inclining the back.
• The occupant must never be left unattended while the wheelchair is reclined.
Fig.19
Fig.17
Fig.16
1-800-MEDLINE (633-5463) | medline.com 13
Fig.20