Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. L
25
To Empty the Dust Bag (Fig. L)
1. While holding the saw, turn the collar
counterclockwise to unlock the dust bag
2. Remove dust bag from the saw and gently shake or tap
the dust bag to empty.
3. Reattach the dust bag back onto the dust port and lock
into place by turning the dust bag collar clockwise.
You may notice that all the dust will not come free from
the bag. This will not affect sanding performance but will
reduce the saw's dust collection efficiency. To restore your
saw's dust collection efficiency, depress the spring inside
the dust bag when you are emptying it and tap it on the
side of the trash can or dust receptacle.
Lower Blade Guard
WARNING: The lower blade guard is a safety
feature which reduces the risk of serious
personal injury. Never use the saw if the lower
blade guard is missing, damaged, misassembled
or not working properly. Do not rely on the
lower blade guard to protect you under all
circumstances. Your safety depends on following
all warnings and precautions as well as proper
operation of the saw. Prior to use, the check
lower guard operation by manually opening the
guard using the lower guard blade retracting
lever then releasing it from the fully open
position. If the guard does not operate smoothly,
close quickly or completely then do not use the
saw and contact your D
repairs. If the lower blade guard is missing or not
working properly, have the saw serviced before
using. To assure product safety and reliability,
repair, maintenance and adjustment should
be performed by an authorized service center
or other qualified service organization, always
using identical replacement parts.
Kerf Indicator (Fig. A, M)
The front of the saw shoe has a kerf indicator
and bevel cutting. This indicator enables you to guide the
saw along cutting lines penciled on the material being
cut. The kerf indicator lines up with the left (outer) side of
the saw blade, which makes the slot or "kerf" cut by the
moving blade fall to the right of the indicator. Guide along
the penciled cutting line so that the kerf falls into the waste
12
22
26
26
25
.
WALT service center for
e
10
for vertical
or surplus material. To adjust the kerf indicator
28
the kerf indicator screw
move the indicator left or right as needed. Tighten screw
when finished adjusting the indicator.
Fig. M
28
Workpiece Support (Fig. J, N–P)
WARNING: It is important to support the work
properly and to hold the saw firmly to prevent loss of
control which could cause personal injury. Figure J
illustrates proper hand support of the saw. Maintain
a firm grip with both hands on the saw and position
your body and arm to allow you to resist kickback
if it occurs. ALWAYS TURN OFF TOOL AND REMOVE
BATTERY BEFORE MAKING ANY ADJUSTMENTS!
Fig. N
Figure N shows proper sawing position. Note that hands
are kept away from cutting area. To avoid kickback, DO
support board or panel NEAR the cut (Fig. O). DON'T support
board or panel away from the cut (Fig. P).
Place the work with its "good" side – the one on which
appearance is most important – down. The saw cuts
upward, so any splintering will be on the work face that is
up when you cut it.
Fig. O
DO support board or panel NEAR the cut.
10
with the blade wrench
10
SUPPORT
, loosen
14
and
Publicidad
