Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
12. Line up the white nubs
with the recesses
28
slots
24
with the two holes
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub
appears in the spool window
22
sure the line doesn't unravel and wrap around the shaft
below the spool.
14. Pull both ends of the cutting line to release them from
the holding slots. If the line extends past the cutting blade
on the guard cut the line so it just reaches the blade.
fig. M
Replacing Spool Housing (Fig. N, O)
1. Rotate the spool housing
spindle
lines up with notch
30
A third hole in the motor housing
shown in figure N. Insert screwdriver through each all
three holes to prevent the spool housing from turning.
2. Turn the spool housing clockwise as shown in figure O.
3. Insert a screwdriver back through the three holes
(
,
, and
) and thread the new spool housing
29
31
32
counterclockwise and securely tighten onto the bolt
protruding from the trimmer.
fig. N
31
32
fig. O
Replacing Guard (Fig. P, Q)
WARNING: Never operate appliance without guard
firmly in place. Damage or personal injury could result.
1. Remove the spool housing as described in the
"Replacing Spool Housing" section.
2. Remove the 4 guard screws
3. Lift the guard off at an angle as shown in figure Q.
10
22
inside the spool housing
of the spool. Align the holding
27
as close as possible.
21
28
22
27
until the hole
11
29
in the guard
31
will be visible as
32
29
30
33
shown in figure P.
34
. Make
4. To attached a new guard, slide the tab
guard under the lip
lower the back of the guard into place as shown in
figure R.
5. Replace and securely tighten the 4 guard screws
6. Replace the spool housing as described in the
"Replacing Spool Housing" section.
in the
.
10
33
Repairs
The charger and battery pack are not serviceable.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D
or a D
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
fig. P
34
34
fig. Q
36
of the motor housing
fig. R
35
WALT factory service center
e
WALT authorized service center. Always use
e
35
of the new
6
, then
.
34
36
Publicidad
Tabla de contenido
