Palmer PWTPB40 Manual De Usuario página 7

Use the articulated feet to screw the power supply unit to the frame, locking it into place with the standard
M8 nut (D). Now place the L-shaped guard strip on the standard M8 nuts (E) and secure it with the M8
flange nuts (F). For technical reasons, the guard strip may only be positioned on the upper side of the
pedalboard.
Positioning the power supply unit elsewhere first requires removal of the cross bar on the upper or lower
edge in order to be able to remove the desired cross bar. Once this has been removed from the frame,
place one of the supplied M6 nuts in each of the appropriate recesses on the shorter side of the power
supply unit and simultaneously guide both sides (with the Velcro tape on the upper side) into the frame's
U-shaped profile. Now screw the power supply unit in with the previously removed M6 socket screw.
D
TECHNICAL DATA
Product number:
Product type:
Type:
Total outputs:
Output connections:
Output voltage:
Output current:
Total inputs:
Input connections:
Controls:
Display elements:
Power supply:
Operating voltage:
Protective circuitry:
Ambient temperature
(in operation):
Relative air humidity:
Housing material:
Housing finish:
Housing color:
Dimensions (W x H x D):
Weight:
Accessories included:
E
PWTPB40 / PWTPB60
Low-voltage power distributor
Power distributor for Palmer PEDALBAY 40 / 60
8 (6x 9 V DC, 2x switchable 9/12/18 V DC) + 1x for forwarding
input voltage
2.1 x 5.5 mm low-voltage sockets
9 V DC or 9/12/18 V DC, outside: positive
Maximum 2 A
1
2.1 x 5.5 mm low-voltage socket
On/Off switch, 2x voltage switches 9/12/18 V
Power LED, 8x status two-tone LEDs
(normal operation = green, error = red)
External power supply, primary voltage 100 – 240 V AC/50–60 Hz
12 V DC, 2 A, outside: positive
Short circuiting and overloading for each output
0° to 40 °C
<80%, non-condensing
Aluminum
Powder coated/anodised
Black
450 x 24 x 50 mm (PWTPB40) / 600 x 24 x 50 mm (PWTPB60)
0.65 kg / 0.7 kg
External power supply with 1.5 m cable, 9x DC cables, 60 cm, with
coaxial power connectors straight to angled, 5x DC cables, 16 cm,
with coaxial power connectors straight to angled, 2x M6 + 2x M8
nuts, 2x M8 flange nuts, Velcro tape, L-shaped guard strip and
4 attachment points for cable ties
F
7