Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully cut the box down the sides then remove the machine
and any accessories from the box. Make sure that all items
listed in the loose parts list are included.
NOTE: This machine is heavy and requires a minimum of
two people to lift. To avoid back injury, lift with your legs and
not your back.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by the
manufacturer and require customer installation. Use of a
product that may have been improperly assembled could
result in serious personal injury.
Inspect the unit carefully to make sure no damage occurred
during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-726-5760 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create accessories
not recommended for use with this product. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not attempt to operate the generator until assembly is
complete. Failure to comply could result in possible serious
personal injury.
LOOSE PARTS LIST
See Figure 3.
The following items are included with the generator:
Key
No.
Description
1
Lock Nut ................................................................. 2
2
Rubber Foot ............................................................ 2
3
Bolt .......................................................................... 2
4
Wheel ...................................................................... 2
5
Washer .................................................................... 2
ASSEMBLY
LOOSE PARTS LIST (continued)
6
Axle ......................................................................... 2
7
Spacer ..................................................................... 2
8
Hitch Pin ................................................................. 2
9
Engine Lubricant ..................................................... 1
Operator's Manual (not shown) ............................... 1
TOOLS NEEDED
See Figure 4.
The following tools (not included or drawn to scale) are needed
for assembly:
Socket Wrenches and/or Combination Wrenches
Phillips Screwdriver
NOTE: Do not put fuel or lubricant in the generator before
installing the feet, frame support, wheels and handle.
INSTALLING FEET ON THE FRAME
See Figure 5.
Locate the following items:
2 rubber feet
2 lock nuts
2 bolts
Insert bolt through rubber foot and then through frame as
shown.
Thread lock nut onto bolt and tighten one full turn past snug.
NOTE: Be careful not to overtighten so that foot material
collapses.
Repeat with remaining foot.
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the same side as
the handle.
Locate the following items:
2 axles
2 hitch pins
2 washers
2 spacers
2 wheels
Raise the end of the generator where the handle is located
high enough to gain access to the frame bottom; securely
position props underneath to support.
Slide the axle through the spacer, then through the hole in
the center of the wheel.
Slide a washer onto the axle, then slide the axle into the
wheel mounting hole as shown.
Insert hitch pin to secure.
NOTE: The hitch pin should be pushed into the axle until
Qty.
the center of the pin rests on top of the axle.
Repeat with the second wheel.
Page 11 — English
Publicidad
