SOMFY SONESSE 30 ZIGBEE Instrucciones página 4

EN
1] Unclip the cover.
2] Clip the new cover on the head.
2.1.2.Preparing the drive
CAUTION
• SONESSE 30 ZIGBEE : interior diameter of the tube has to be Ø28,8 mm or greater.
• The crown is mandatory.
1] Fit the accessories required to integrate the drive into the tube:
ð Fit the crown (a) and the wheel (b) to the drive.
2] Measure the length (L) between the inner edge of the drive head and the rim
of the wheel.
2.1.3.Preparing the tube
1] Cut the tube to the required length.
2] Deburr the tube and remove the debris.
2.1.4.Assembling the drive-tube
1] Slide the drive into the tube. For tubes with a smooth interior, position the cut
notch on the crown.
2] The wheel must be locked in place to prevent any movement in the tube.
▪ This can be achieved by fastening the tube to the wheel using self-tapping screws, or steel pop rivets, placed between
5 mm and 15 mm from the outer edge of the wheel, regardless of the tube.
▪ or by using a wheel lock, for non-smooth tubes.
CAUTION
The screws or pop rivets must only be fastened on the wheel and not on the drive.
2.1.5.Installing the drive-tube assembly
CAUTION
• The motorised product must not be compressed between the brackets.
• Do not use the plastic cross without the metal bracket adapter.
▪ The drive can be fixed directly onto the drive bracket (the screw holes are spaced 29 mm apart). Use 2 screws (3.5 x
9 mm). A manual tightening torque of 1 Nm is recommended.
4
1]
2]
1]
1]
2]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
SONESSE 30 ZIGBEE
a
b
2]