Publicidad
Idiomas disponibles
Idiomas disponibles
SONESSE 30 ZIGBEE
▪ Drive plates are also available in the current catalogue (Select the correct drive
plate adapted to the bracket and check the torque requirements in the system).
Use the 2 screws (3 x 6 mm) delivered with the motor plate. A manual
tightening torque of 0.6 Nm is recommended.
1] Screw the bracket adapter to the drive head.
2] Install and fix the drive-tube assembly onto the end bracket (c) and onto the
drive bracket (d).
CAUTION
• Do not let the tube hanging by the head side only.
• Ensure that the drive-tube assembly is secured onto the end bracket. This operation prevents the tube-drive
assembly from coming out of the end bracket attachment.
• Light gap reduced: Do not pinch cable or be careful they are not in contact with moving parts.
2.2.Compatible power supplies (for US only)
For USA and CANADA, use only SOMFY power supply listed in the leaflet. For other countries, see Compatibility Matrix
document for appropriate power supply.
References
1870196
1870192
1870197
1870198
1870259
2.3.Wiring
WARNING
To ensure electrical safety, this Class III drive must be powered by a "class 2" power source (SELV -Safety Extra Low
Voltage) + LPS (Limited Power Supply).
Connect the drive to the power supply:
▪ Black wire: -
▪ Red wire: +
PRECAUTION
• Cables routed through a metal wall must be protected and insulated by sleeving or sheathing.
• Secure the cables to prevent any contact with moving parts.
• If the drive is used outdoors and if the power supply cable is of the H05-VVF type or PVC type, run the cable in a
UV-resistant duct, e.g. trunking.
• The drive cable cannot be removed. If it is damaged, return the drive to the After-Sales department.
©
Copyright
2023 SOMFY ACTIVITES SA. All rights reserved.
Designations
5 motors / Somfy Control Distribution panel
10 motors / Somfy Control Distribution panel
15 motors / Somfy Control Distribution panel
20 motors / Somfy Control Distribution panel
Somfy Power Panel
EN
c
d
5
Publicidad
