Publicidad
Idiomas disponibles
Idiomas disponibles
Round Base Pad Installation
Step 2: Use PVC glue on the inside of the bulkhead assembly and around the center of the water
supply pipe. Be careful not to get any glue on the LED light. With two people, carefully lower the bowl
and bulkhead assembly over the niche pipe so it rests firmly on the niche flange.
Step 3: Screw the water spout assembly into the bulkhead assembly in the center of the bowl as
shown above.
When operating the Water Bowl,
but the gpm can vary as the ideal water effect is up to the user's personal preference. See chart
below for gpm range.
Manual Control
Turn on power to the pump controlling the Water Bowl system as well as the switch for the LED
light(s). Adjust the flow control valve(s) until the ideal water effect is achieved in the bowl.
The LBCUS11100LP & LBCUS11150LP lights can be controlled in 2 modes: P-mode and Water Fire
mode. In P-mode, manually toggling power to the lights (quickly turning the light off and then back
on) will change the color of the light. In Water Fire mode, the light will flicker in a red-orange color to
simulate a fire effect in the Water Bowl feature. The factory default mode is Water Fire mode.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Operation
it is recommended to keep the water flow between 15-20 GPM,
GPM Range
< 10 gpm
10 - 24 gpm
15 - 20 gpm
≥ 25 gpm
(LBCUS11100LP & LBCUS11150LP)
Square Base Pad Installation
Outcome
Not enough water flow
Acceptable range
"Ideal" range
Bowl will overflow
10
Publicidad
