Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Turn off light for between 11-15 seconds, then turn on for 2 seconds.
5.
The light should now be blinking white and a color corresponding to the current light mode.
To change modes, toggle the light off then back on. The light should now be blinking white
and a different color. Refer to the chart
6.
Once the light is blinking in the sequence corresponding to the desired light mode, turn off
light for 1 minute. The light should now be in the desired mode.
Winterization
Follow the steps below for winterizing the Water Bowl. Note that in areas where a deep freeze can
occur, the bowl should not be allowed to fill will water, as the ice can damage the bowl when it ex-
pands. It is recommended to either cover the bowl or fill it will pool anti-freeze.
1.
Completely drain water from the water supply line and the bowl.
2.
Unscrew the water spout assembly from the center of the bowl and store it someplace safe.
3.
Screw in a 11/2" threaded plug to the center of the bowl.
4.
Cover the bowl or fill it with pool anti-freeze.
LED Light Replacement
Follow the steps below to replace the LED Light assembly in an existing installation.
1.
Remove all power from the LED Light system and disconnect the wires from the LED Light at
the junction box/low voltage transformer.
2.
Completely drain any water from the bowl.
3.
Unscrew the water spout assembly from the center of the bowl, revealing the retaining nut on
the bulkhead assembly.
4.
Unscrew and remove the retaining nut and gasket from the center of the bowl to release the
bowl.
5.
With two people, remove the bowl by lifting it straight up and carefully set it aside.
6.
Remove the old LED Light assembly from the niche and pull the cord out.
7.
Install the new LED Light assembly by following the Electrical Wiring steps starting on page 7.
8.
Restore power to the LED Light system and turn the LED Light on to verify operation.
9.
Re-install the bowl onto the Niche pipe followed by the gasket, retaining nut, and water spout
assembly.
13
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
below
Blink Sequence
White / Red
White / Purple
Maintenance
for light mode colors.
Light Mode
UCL
Omni Direct
Publicidad
