True Spec Serie Manual De Instalación página 14

Installation & Setup
Leveling Screw, Leg, or Castor Installation
Tipping hazard!
or castors can cause a tipping hazard.
ALWAYS be sure leveling legs or castors (and shims)
are snug against the rail assembly or mounting plate.
ALWAYS verify center castors or leveling legs fully
contact the floor after leveling the appliance. See fig.
below.
Leveling screws assist the leveling of the cabinet. Adjustable legs
provide 6" (153 mm) of clearance under cabinet. Castors provide
appliance mobility. Always use shims when adjusting castors.
Fig. 1. Leveling screw.
Rail End
Snug Fit
Here
Fig. 2. Parts of an adjustable leveling leg. Adjust the bottom stem to level
appliance.
Page 14 of 240
WARNING!
Incorrect installation of leveling legs
Lower Rail Assembly
Bottom Stem
QUICK START MANUAL
Install castors with brakes in the front.
Top View
Left
Shim in
Position
Leveling Shims
Fig. 3. Platform castor and shims. Install shims in pairs.
Rail End
Snug Fit
Here
Bearing
Race
Castor
Fig. 4. Stem castor and shims. Install multiple shims with offset slots.
08/3/2023
USER ACTION!
Leveling Shims
Lower Rail Assembly
Castor
Stem
Leveling
Shim
P#844594 TEC_TM_169 | REV. B | ALL
truemfg.com
Snug Fit
Here
Castor
Mounting
Plate
Castor
Side View