Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
3
Making the electrical connection
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
IMPORTANT: Use the wire connecting nuts (DD) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
NOTE: The fan comes with 54 in. lead wires for use with
an extended ball/downrod assembly. If using the 6 in. ball/
downrod assembly (B) provided, you can cut the lead wires to
your desired length (no shorter than 12 in.).
□
The fan comes with 54 in. lead wires for use with an extended
ball/downrod assembly. If using the 6 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 12 in.) This will make extra
room in the canopy (C), if you do not wish to cut the wires,
you will need to neatly wrap them.
□
Connect the fan motor green wire(s) to the household green
or bare wire using a wire connecting nut (DD).
□
Connect the fan motor white wire to the household white wire
using a wire connecting nut (DD).
□
Connect the fan motor black and blue wires to the household
black wire using a wire connecting nut (DD).
□
Secure each wire connecting nut using electrical tape.
□
Turn the wire connecting nut (DD) upward and push the wiring
into the outlet box (MM).
Black
Blue and Black
A
B
C
Outlet Box
MM
Green or Bare
White
Green
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket,
under the receiver.
□
Secure with electrical tape.
DD
9
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM
Publicidad
