Makita DHS710ZJ Manual De Instrucciones página 6

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Battery indicator
5. Overheat indicator
6. Star marking
7. Indicator lamps
8. Check button
9. Lever
10. Front lever
11. Rear wing nut
12. Stopper
13. Cutting line (0° position)
SPECIFICATIONS
Blade diameter
Max. cutting depth
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
6
Explanation of general view
14. Cutting line (45° position)
15. Screw
16. Switch trigger
17. Lock-off lever
18. Hex wrench
19. Loosen
20. Tighten
21. Shaft lock
22. Mounting shaft
23. Inner flange
24. Saw blade
25. Outer flange
26. Hex bolt
Model
-1
)
Net weight
BL1815N/BL1820/BL1820B/BL1830/BL1830B/BL1840/BL1840B/BL1850/
at 0°
at 45°
at 50°
BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
Save all warnings and
ENE078-2
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
CORDLESS CIRCULAR SAW
SAFETY WARNINGS
GEA010-2
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
27. Ring
28. Dust nozzle
29. Vacuum cleaner
30. Hose
31. Clamping lever
32. Rip fence (Guide rule)
33. Adjusting screw for 45°
34. Adjusting screw for 0°
35. Triangular rule
36. Base
37. Limit mark
38. Screwdriver
39. Brush holder cap
DHS710
185 - 190 mm
66 - 68.5 mm
47.5 - 49 mm
42.5 - 44 mm
4,800
356 mm
3.9 - 4.6 kg
D.C. 36 V
GEB151-1