Publicidad
Idiomas disponibles
Idiomas disponibles
Wear hearing protection.
The effects of noise can cause a loss of hearing.
7.
Before starting the equipment
Open the packaging and remove the device carefully.
Remove the packaging material as well as the packag-
ing and transport bracing (if available).
Check that the delivery is complete.
Check the device and accessory parts for transport
damage.
If possible, store the packaging until the warranty pe-
riod has expired.
ATTENTION
The device and packaging materials are not toys! Chil-
dren must not be allowed to play with plastic bags, film
and small parts! There is a risk of swallowing and suf-
focation!
Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identical
to the mains data.
• Report any damage immediately to the transport
company which was used to deliver the power tool.
• Avoid long supply lines (extension cables).
• Do not operate the power tool in a damp or wet room.
• The power tool may only be operated in suitable
rooms (well ventilated).
8. Attachment and operation
Installation (fig. 2-3)
- Fold the front and back part together. And then tight-
en the Set Screw (3).
Fitting the telescopic extension (fig. 4)
Insert the telescopic extension (11) into the connection
for the telescopic extension (12) and lock it by twisting
as shown in fig. 4.
Note: Adjust the Telescopic Plasterboard Sander with
the telescopic extension (11) so that you can work with
it most comfortably. The machine can also be used
without telescopic extension.
26 | GB
Sandpaper
Selection
1.
The grain size of the sandpaper is specified on its
rear side. The smaller the specified number, the
coarser the graining.
2.
Use sandpaper with coarse grain for rough grind-
ing, and sandpaper with fine grain for finishing.
We recommend sandpapers with aluminium ox-
ide, silicon carbide or other synthetic abrasives.
3.
lf you can chose between sandpapers with differ-
ent graining, you should start with coarse grain-
ing sandpaper and complete the grinding process
with the finest possible graining. Thus you will get
good and smooth grinding results.
How to apply and replace sandpaper
1.
Apply the sandpaper (16) to the grinding plate (1)
using the Velcro strip mechanism.
2.
Align the sandpaper (16) with the grinding plate
(1) and press it on evenly.
3.
PuII the sandpaper (16) off the grinding plate (1)
and replace it with a new one / another one (fig. 7).
Dust extraction
WARNING! Harmfull noxious gases may be generated
when e.g. lead-containing paint is processed. These
gases entail a risk for the operator and the persons
in the vicinity!
Therefore only use the power tool in combination with
a dust extraction unit, and protect yourself and other
persons in the working area with additional suitable
personal protective equipment!
When working with this power tool, a Iot of dust is
generated. The dust extraction unit is very useful if
you want to keep your workplace clean. lt is possible
to combine the extraction system or a vacuum cleaner
with the extraction hose (14) which is connected to the
adapter for dust extraction.
Insert the hose adaptor (15) into the connection for dust
extraction (10 or 12) and lock it by twisting as shown in
fig. 5 and 6.
Note: Connect your tool to an extraction unit or vacuum
cleaner. This will provide excellent extraction of dust
and debris.
m Attention! For health safety reasons it is imperative
that you use a dust extractor.
www.scheppach.com
Publicidad
