LG FH069FDF Manual Del Usuario página 17

16
INSTALLATION INSTRUCTIONS
Connecting the drain line
Secure the drain hose in place to prevent
moving and leaking.
NOTE
• The drain hose should be properly secured.
Failure to properly secure the drain hose
can result in flooding and malfunction.
• Total height of the hose end should not
exceed 39,4 inches (100,0 cm) from the
bottom of the washer.
• The drain must be installed in accordance
with any applicable local codes and regula-
tions.
• Make sure that the water lines are not
stretched, pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow
bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
Elbow Bracket
2
Insert the end of the drain hose into the
standpipe.
3
Use a tie strap to secure the drain hose in
place.
Elbow Bracket
Drain Hose
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold, or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
Elbow Bracket
2
Hang the end of the drain hose over the side
of the laundry tub.
3
Use a tie strap to secure the drain hose in
place.
Connecting the auto dosing
1
Unscrew the 2 screws on the protective
cover and remove the cover.
2
Connect the auto dosing harness from
Accessory parts.
NOTE
• The voltage of the auto dosing machine
should be the same as the washer's voltage.
Elbow
Bracket
Laundry Tub
max. 39,4"
max. 39,4"
(1,0 m)
(1,0 m)
Drain Hose
Tie Strap