Pontec PondoClear Island 3000 Instrucciones De Uso página 12

- EN -
How to proceed:
1. Clean the float unit.
2. Dismantle and clean the nozzle unit.
3. Disassemble the unit. (→ Clean the coarse dirt filter)
4. Clean the filter housing of the pump and impeller unit. (→ Replacing the impeller unit)
5. Clean the UVC water housing and quartz glass. (→ Cleaning the UVC water housing and quartz glass)
6. Reassemble the unit in the reverse order.
Clean the coarse dirt filter
How to proceed:
 C
1. Release the net from the coarse dirt filter and remove.
– The net is attached to the filter with hooks at 4 points.
2. Undo the screw and remove.
3. Turn the coarse dirt filter in the direction OPEN as shown by the arrow.
4. Lift the float unit from the coarse dirt filter and clean the inside and outside of the filter.
Replacing the impeller unit
How to proceed:
 D
1. Pull the pump (covered by the foam filter) from the pipe bend and then take it out of the foam filter.
 E
2. Pull the filter housing from the pump (bayonet closure).
3. Pull out the impeller unit and clean or replace.
4. Reassemble the unit in the reverse order.
Cleaning the UVC water housing and quartz glass
How to proceed:
 D
1. Pull the pump (covered by the foam filter) from the pipe bend.
2. Undo and remove the union nut from the UVC water housing by turning it counterclockwise.
3. Pull out the UVC unit.
4. Clean the UVC water housing on the inside and outside.
5. Check the quartz glass for damage and wipe it on the outside with a damp cloth.
6. Reassemble the unit in the reverse order.
Replacing the UVC lamp
Attention! Breakable glass.
Possible consequences: Injury to your hands caused by cuts.
Protective measures: Handle the quartz glass and UVC lamp with care.
The UV-C lamp has to be replaced after approx. 8000 operating hours. Only use UV-C lamps the designation and ra-
ting of which match the information on the type plate.
To replace the UVC lamp open the UVC water housing. (→ Cleaning the UVC water housing and quartz glass)
How to proceed:
 F
1. Remove the quartz glass by carefully turning and pulling it off the UVC lamp.
2. Pull the UVC lamp out of the lamp socket and replace it with a new one.
3. Reassemble the unit in the reverse order.
12