Publicidad
Second step: THE BACK OF THE HEAD
• Put in one of the two guides corresponding to the desired
length of 7 or 9 mm. and cut the area at the back of the head,
identified as zone "B" in the figure.
Third step: SIDES
• Using the 3 or 7 mm. cutting guides, start cutting the side
burns and the area close to the ears. Next, use the guide
corresponding to the cutting length 9 or 12 mm. to go on
cutting the hair at the top of the head.
Fourth step: The top of the head
• Put in the guide corresponding to the longest cutting length
(12 mm.) and start cutting from the crown forwards against
the growth of the hair. In some cases you will have to cut from
the front backwards.
• To leave your hair longer use a comb to lift the hair at the
back of the head and cut above the comb; or else hold the
lock of hair between your fingers and cut off the to the desired
length.
• Always working your way from the back of the head, gradually cut the hair, shorter each
time by reducing the space between the comb or your fingers to the hair. Frequently comb
your hair to check for any differences in its length and to eliminate the hair which has already
been cut.
Fifth step: THE FINAL TOUCHES
• Do not use any guides for the final touches.
• To get an exact hair cut, and the side burns, nape and the area around the ears with straight
lines, turn the hair clippers round and place them at a straight angle with your head so the
blade is in slight contact with the skin, and shave downwards. This way you will get a perfect
finish, as if shaving.
ADJUSTABLE LEVER
• You can use the adjustable lever for finished and retouched, specially round the neck and
ears.
• To increase the cut distance put down the
lever.
• To reduce the cut distance put up the lever.
TRIM THE BEARD
• Always remember you must begin with the
longest cutting guide (12 mm.) before using
one of the shorter guides.
• Start by cutting from below the chin and
moving the clipper with soft movements
upwards and outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVISION OF MUSTACHE
• Comb the moustache downwards.
• Start with the higher cutting guide. Later you may use the shorter cutting guides.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the clipper is unplugged from the mains.
• Use the brush to take off rests of hair in the blade.
• In case the blade has been dismantled for its replacement or cleaning, it must be adjusted
again. To do so, slacken lightly the screws placed at the bottom of the blade
• Use your fingers to move horizontally the blade until the ends are in perfectly aligned.
• The tooth of the up blade must be moved back 1, 2 mm. approximately, with regard to the
tooth of the down blade
9
Publicidad
