Installation Instructions; Tools Needed; Parts Supplied; Location Requirements - Haier HLP24E Manual Del Usuario

InsTaLLaTIon InsTRUCTIons

TooLs nEEDED

•
Pliers
•
Wrench
•
Flat-blade Screwdriver

PaRTs sUPPLIED

•
Drain Hose Clamp
•
Drain Hose Hook
•
Drain Hose

LoCaTIon REqUIREMEnTs

•
T he washer must be installed on a solid floor to minimize vibration during the
spin cycle. A concrete floor is best.
•
T he floor should be level with maximum slope of 1" (25 mm) under entire washer.
•
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
•
Do not install on carpeting.
•
The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of
power cord on the back of the washer.
•
Water faucet must be present within 3 ft. (0.9 m) of the connection on the
washer.
•
Only connect to cold water tap (faucet).
•
The water pressure should be between 20 and 100 psi (138 and 690 kPa).
Do not install or operate the washer where it will be exposed to
temperatures below 32°F (0°C). Water remaining in the washer will
freeze and cause damage to the washer.
•
Measuring Tape
•
Carpenter's Level
•
Water Hose
(flat washers pre-installed)
•
User Manual
WARNING
5