Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
9
Removing the plastic cap
□
Before installing the escutcheon (E), remove the
plastic cap (1) from the valve body (D) by twisting
the cap in a clockwise direction when the depth
distance (which is measured from the center of
the shower outlet to the nished wall surface) is
2-1/4 in. to 2-1/2 in.. Or unscrew the screws (K)
and remove the plaster guard (L) when the depth
distance (which is measured from the center of
the shower outlet to the nished wall surface)
is 1-1/2 in. to 2-1/4 in..
10
Adjusting the temperature
NOTE: The limiter on the valve can be set to allow partial or full access to hot water by limiting how far the handle can be turned to the
hot side of the valve. The limiter is typically set at the factory to allow only warm water to pass through the valve. Follow the directions
in this section if you wish to adjust the amount of hot water that is allowed through the valve. If you do not wish to adjust the amount
of hot water that is allowed through the valve, proceed to the step 11, and skip over the step 10 (A, B, C, D).
A
Removing the sleeve
□
Unscrew the sleeve (1) from the valve body (D).
1
B
□
D
12
D
1
OR
K
Removing the red limit stop ring
Make sure the cartridge assembly (2) is in the off
position. Remember the position of the red limit
stop ring (1) on the cartridge assembly (2).
Remove the red limit stop ring (1) from the
cartridge assembly (2).
D
L
1
2
Publicidad
