Publicidad
Idiomas disponibles
Idiomas disponibles
| EN |
Lifting
1. Prior to operating the jack, remove any accumulated air from the system below:
-Pull the handle and tum it counterclockwise whilst held in this position, pump the jack several
times to ensure internai lubrication and bleed the accumulated air from the system.
2. Refer to the vehicle manufacturer's own manual to locate approved lifting points on the
vehicle. Center jack saddle under lift point.
3. This jack is fitted with a foot pedal that gives a faster approach to the load.
4. Pump handle full stroke until load reaches desired height.
5. Transfer the load to appropriately rated jack stands.
Lowering
1. Raise the vehicle and clear the jack stands.
2. Pull up the handle then turn the handle counter-clockwise. The handle is self-return (Dead-
man principle ),you need to hold the handle until the jack back to the initial position.
Publicidad
