Sauder Manhattan Gate Serie Instrucciones De Montaje página 6

Step 3
å
You have the option to fasten your Hutch to the 429249 or the 429250.
å
The same attachment method is used for both base units. This book will show your hutch being fastened to the 429249.
å
1 - With someone's help, place the hutch onto the base top. Center the hutch on the base unit with the back edges even
st
with the back edge of the base top. Then, using your pencil, make marks through the holes in the ENDS (C and D).
å
2 - Remove the hutch from the base top.
nd
å
3 - Drill a 5/32" hole into each of the four marked locations on the base top.
rd
å
4
- Fasten the ENDS (C and D) to the base top. Tighten four 2-3/8" HEX HEAD SCREWS (2) using the L-WRENCH (3).
th
3
2-3/8" HEX HEAD SCREW
Page 6
Electric drill with 5/32" bit
4
th
2
(4 used in this step)
www.sauder.com/service
After marking the
holes, remove your
hutch to drill the holes.
2
nd
C
1
st
3
rd
D
429251