Sauder Manhattan Gate Serie Instrucciones De Montaje página 7

Step 4
å
Place your unit in its final location against a wall. Use the FURNITURE TIPPING RESTRAINT KIT (96) for added stability.
å
The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a wall stud,
go to the next step now.
å
1 - Locate the center of a stud in your wall near your unit and mark it with a pencil just below the top surface of your
st
unit so the SAFETY STRAP will not be visible.
å
2 - Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3 - Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
rd
Mark and drill
a 1/8" hole into
the wall stud.
1
st
429251
Electric drill with 1/8" bit
2
nd
3
rd
96
www.sauder.com/service Page 7