Sauder Cannery Bridge Serie Instrucciones De Montaje página 20

Step 15
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the RIGHT DOOR (J) to the RIGHT END (B)
as shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
å
Repeat this step for the other DOOR (H).
å
Peel BUMPERS from the BUMPER CARD (11) and stick
them onto the DOORS (J and H) as shown.
å
See the next step for DOOR adjustments.
Page 20
A
www.sauder.com/service
B
H
17
Stop
Mounting
screw
Adjusting
screw
Hinge
J
11
429515