Sauder Costa Serie Instrucciones De Montaje página 22

Step 17
å
NOTE: We have provided a Nail Holder to use in this step for proper positioning of the NAILS. Please refer to the parts of
the Nail Holder as the bead, offset edge, and nail slot as shown in the diagram below.
å
Place the CENTER BACK (N) over your unit with the top edge of the CENTER BACK against the bottom surface of the TOP (V).
å
NOTE: The bottom edge of the CENTER BACK should have six NAILS and the side edges of the CENTER BACK should
have five NAILS on each side edge. The NAILS should be placed approximately 5" apart and 2" in from the edges. Follow
the enlarged diagrams below.
å
To fasten the bottom edge of the CENTER BACK (N), place the offset edge of the Nail Holder down against the
BOTTOM (G). Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into the edge of
the BOTTOM. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer.
å
To fasten the side edges of the CENTER BACK (N), place the bead of the Nail Holder down between the CENTER BACK
and BACK (U). Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into the edge of
your unit. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer.
5"
2"
bead
NAIL
(16 used in this step)
Page 22
1N
5"
2"
offset edge
U
N
G
428193
offset edge
Nail
Holder
bead
V
U
www.sauder.com/service
nail slot