Sauder Costa Serie Instrucciones De Montaje página 9

Step 4
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (C) onto the ENDS (A and B).
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again. The MOLDINGS should be
even on both edges of the ENDS.
www.sauder.com/service
A
C
B
BLACK 9/16" FLAT HEAD SCREW
428193
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
32S
(4 used in this step)
C
Page 9