Publicidad
Step 6
Step
å
Fasten the UPRIGHT (C) to the FIXED SHELF (D). Use two BLACK 1-15/16" FLAT HEAD SCREWS (113S).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
If you purchased the LED Light (426494), push a CORD CLIP (4P) into the hole in the FIXED SHELF (D).
å
NOTE: The CORD CLIP is used to hold the cord against the FIXED SHELF.
å
If you did not purchase the LED Light (426494), push the HOLE PLUG (126P) into the hole in the
FIXED SHELF (D).
4P
113S
BLACK 1-15/16" FLAT HEAD SCREW
(2 used in this step)
www.sauder.com/commercial-office/service
126P
D
427429
C
u t
i t h o
e w
®
f a c
C K
S u r
- L O
I S T
E R S
T W
T E N
F A S
Page 11
Publicidad
