Publicidad
Step 10
å
Carefully stand your unit upright.
å
Fasten the BACKS to the ENDS (A and B), FIXED SHELF (D), and TOP (J). Tighten fourteen HIDDEN CAMS.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the adjusting screw and mounting screw to slide it against the stops. Then tighten the
mounting screw.
å
Fasten a OUTER DOOR (E) to the LEFT END (B) as shown in the lower diagram. Use the screws in the HINGES.
You should start each SCREW a few turns before completely tightening any of them.
å
Repeat this step for the other DOOR (E).
å
Peel the BUMPERS from a BUMPER CARD (29M). Stick the BUMPERS on the FIXED SHELF (D) where it comes
into contact with the OUTER DOORS (E).
E
www.sauder.com/commercial-office/service
B
D
29M
1
J
E
427429
1
17
17
Stop
Mounting
screw
Adjusting
screw
Hinge
A
Page 15
Publicidad
