Sauder Clifford Place Serie Instrucciones De Montaje página 27

Step 22
Fasten the HINGES on the DOORS (X and Y) to the HINGE BRACKETS on the ENDS (A and B).
å
Follow the large diagram below fastening both HINGES to the HINGE BRACKETS keeping the DOOR vertical at all times.
å
Fasten two PULLS (10) to the DOORS (X and Y). Use four BLACK 1/2" FLAT HEAD SCREWS (23).
å
Refer to the enlarged diagram to identify the parts on the HINGES.
å
The DOORS may need some adjustments. Follow the text below to make needed adjustments.
å
DOOR ADJUSTMENTS:
å
To adjust the DOORS from side to side (horizontal), turn the adjusting screw in or out.
To adjust the DOORS up and down (vertical), loosen both vertical adjustment screws. Move the DOORS up or down to
å
the desired location. Tighten the screws after making adjustments.
To adjust the DOORS in or out (depth), loosen the mounting screw one turn and move the DOORS in or out, as
å
needed. Tighten the mounting screw after making adjustments.
Adjusting screw (horizontal)
B
429507
Mounting screw (depth)
(vertical adjustment)
Y
www.sauder.com/service
A
10
This screw will fi t
into this slot. Then
tighten the screw.
23
BLACK 1/2" FLAT HEAD SCREW
(4 used for the PULLS)
X
10
The screw on the back
side of the HINGE will
fi t into this slot.
Page 27