Sauder Clifford Place Serie Instrucciones De Montaje página 8

Step 3
Separate the EXTENSION SLIDES (FF) from the EXTENSION RAILS (EE) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (EE) to the ENDS (A and B). Use six BLACK 1/2" PAN HEAD SCREWS (21).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the holes in the ENDS. Turn a SCREW
into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten the HINGE BRACKETS (11) to the ENDS (A and B) exactly as shown. Use the SCREWS in the brackets.
å
Push the black lever up and
pull the SLIDE from the RAIL.
Open end
11
Page 8
FF
BLACK 1/2" PAN HEAD SCREW
(6 used for the RAILS)
EE
B
www.sauder.com/service
Open end Use these holes.
21
EE
7
EE
Open end
A
11
429507