Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 14

Step 11
å
Your unit may need leveling. To raise a corner of your unit, rotate the LEVELER
downward. To lower a corner of your unit, rotate the LEVELER upward.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against
the stops as shown in the right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten the mounting screw.
å
Fasten one of the DOORS (H) to the RIGHT END (A) as shown in the lower
diagram. Use the screws in the HINGES. You should start each SCREW a few
turns before completely tightening any of them.
å
Fasten one PULL (195K) to the DOOR (H). Use two SILVER 7/8"
MACHINE SCREWS (42S).
å
Repeat this step for the other DOOR (H).
å
See the next step for DOOR adjustments.
To raise a corner of your
unit, rotate the LEVELER
downward. To lower a
corner of your unit, rotate
the LEVELER upward.
Page 14
B
A
427438
Stop
Mounting
screw
Adjusting
screw
H
SILVER 7/8" MACHINE SCREW
(4 used in this step)
www.sauder.com/commercial-office/service
17
Hinge
195K
42S