Sauder Steel River Serie Instrucciones De Montaje página 10

Step 4
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten four EXTENSION RAILS (1) to the EXTENSION BLOCKS (F). Use eight 1/2" FLAT HEAD SCREWS (21)
through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
slide the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the
EXTENSION BLOCK. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
1/2" FLAT HEAD SCREW
(8 used in this step)
1
1
st
1
Open end
Page 10
21
Slide the black lever in and pull the SLIDE from the RAIL.
The post
must be here.
1
st
1
st
F
1
F
www.sauder.com/service
hole shown in the enlarged diagram. Then,
st
2
1
1
st
F
T
S
7
Open end
1
st
1
F
427855