Sauder Steel River Serie Instrucciones De Montaje página 15

Step 9
å
NOTE: In this step, pay close attention to the holes used in the RAILS (1).
å
Push two HIDDEN CAMS (9) into the UPRIGHT (V).
å
Fasten one EXTENSION RAIL (1) to the surface with HIDDEN CAMS on the UPRIGHT (V). Use two 1/2" FLAT HEAD
SCREWS (21) through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT. Turn a SCREW
into this hole.
å
Flip the UPRIGHT (V) over, and fasten one EXTENSION RAIL (1) to the other surface of the UPRIGHT. Use two 1/2"
FLAT HEAD SCREWS (21) through the exact holes shown.
1/2" FLAT HEAD SCREW
(4 used in this step)
Arrow
1
st
V
427855
21
9
1
1
Open end
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the inner
st
1
st
V
1
Use these holes.
1
st
Use these holes.
1
1
st
Open end
1
Page 15