Sauder Clifford Place Serie Instrucciones De Montaje página 8

Step 3
å
Separate the EXTENSION SLIDES (FF) from the EXTENSION RAILS (EE) as shown in the enlarged diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (EE) to the ENDS (A and B). Use six BLACK 1/2" PAN HEAD SCREWS (21).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the ENDS. Turn a SCREW
into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten the HINGE BRACKETS (11) to the ENDS (A and B) exactly as shown. Use the SCREWS in the brackets.
Push the black lever up and
pull the SLIDE from the RAIL.
Open end
11
Page 8
FF
BLACK 1/2" PAN HEAD SCREW
(6 used for the RAILS)
EE
B
www.sauder.com/service
Open end Use these holes.
21
EE
7
EE
Open end
A
11
433365