Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRIC PRUNING SHEAR
12. ASSEMBLE BATTERY
13. OPERATION START PROCEDURE
Please wear suitable cloth and glove when operate this tool. Always
check tools before use, make sure on/off switch and safe switch are
all ok. The power should be put off when you loosen the trigger.
Stop using the tool in case of switch failure. Always check rated voltage of
battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure
blade stop fully before touch it, otherwise blade will hurt your body.
•
Turn on the power switch. After warning tone, please pull the trigger two
times without holding. And the shear will be on working condition after
one more warning tone. Don't overload cutting, it will protect pruning shear
and battery not be damaged.
•
Don't cutting over the dimension specified in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the
blade will resume maximum position.
Please check that the pruning shears, wires and
batteries are clean and dry, and then follow the steps
below to assemble:
•
Place the battery pack in the battery compartment
and secure the. Make sure that the connector is
facing right if you are righthanded.
•
Check the opening and closing position of the
pruning shears.
•
Grip the handle with your hands.
•
Turn on the power switch, pull two scissors to the
trigger in a row and open the scissor head. You can
start the operation.
www.gruposanz.es
69
Publicidad
