Steelcase Migration SE Guía Rápida página 21

Configuring memory positions
height is reached.
=
The display indicates the desk height (e.g. 73 cm).
2. Press the "SAVE" button.
3. Press the desired "Memory position" button (e. g.
button "2")
=
The display indicates S 2.
ü The display indicates the desk height after roughly 2
seconds.
Calling up memory positions
1. Press and hold the corresponding memory position
button (e.g. button "1" or button "2").
ü The desktop is moved until the stored desktop height
is reached. The desktop movement is stopped
whenever the button is released before the memory
position has been reached.
Changing the displayed unit – CM/INCH
1. Simultaneously press and hold the buttons "1", "2"
and "Up" for three seconds; then release the
buttons.
=
The letter S and a number (e.g. S 7) are indicated
on the display.
2. Press and hold the "Up" button until S 5 is indicated
on the display.
=
S 5 is displayed.
3. Press the "SAVE" button.
ü If the display was previously set to centimetres (cm),
it will now be switched over to inches (inch) and vice
versa.
4 Operating and adjusting
EN
21