Steelcase Migration SE Guía Rápida página 26

5 Errors and faults
5.2.1 Table of error messages with the Up/Down
control panel
Signal/Code
Lamp not lit
Flashing red
EN
Flashing green
26
Message Required measure(s)
Normal system The DM system can be used
operation as usual
The system is not Instructions on how to
correctly connected correctly connect the system
can be found in the DM
system manual
Warning - System Release all buttons and wait
error 5 seconds. Then try to
repeat the action.
Disconnect the DM system
from the power supply.
(If a power lift is used)
disconnect the power lift
from the mains. Check the
power supply system for
overheating. Let it cool if
required. Check all cable
connections and re-connect
the system.
Should the problem persist:
■ Perform a "manual reset".
■ Contact LOGICDATA.
System starts up To carry out any subsequent
steps, wait until the LED is
The system is being
no longer flashing. Do not
reset
press any buttons!
Duty cycle exceeded
Collision detected Remove the obstacle from
(ISP) the table system. Remove
any unnecessary loads from
the desktop. The DM system
can be used as usual .