Bosch 0 601 58J 306 Manual Original página 19

OBJ_BUCH-1257-001.book Page 19 Thursday, July 15, 2010 9:04 AM
When the cut is completed, switch off the
machine and then pull the saw blade out of
the cut only after it has come to a standstill.
In this manner you can avoid kickback and
can place down the machine securely.
Use only sharp, flawless saw blades. Bent or
unsharp saw blades can break or cause kick-
back.
Do not brake the saw blade to a stop by ap-
plying side pressure after switching off. The
saw blade can be damaged, break or cause
kickback.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight,
fire, water, and moisture. Danger of
explosion.
In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints. The vapours can irritate the
respiratory system.
Use the battery only in conjunction with
your Bosch power tool. This measure alone
protects the battery against dangerous over-
load.
Use only original Bosch batteries with the
voltage listed on the nameplate of your pow-
er tool. When using other batteries, e. g. imi-
tations, reconditioned batteries or other
brands, there is danger of injury as well as
property damage through exploding batteries.
Bosch Power Tools
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-off button for On/Off switch
2 On/Off switch
3 Battery*
4 Battery unlocking button
5 Allen key
6 Plastic guide plate
7 Base plate
8 Adjusting lever for orbital action
9 Guide roller
10 Lead for the parallel guide
11 Saw blade*
12 SDS clamping lever for saw blade release
13 Contact protector
14 Handle (insulated gripping surface)
15 Button for charge-control indicator*
16 Battery charge-control indicator*
17 Stroke rod
18 Vacuum connection*
19 Vacuum hose*
20 Splinter guard
1 609 929 W85 | (15.7.10)
English | 19