sylvac ULH4 Modo De Empleo página 7

3.1 Automatic references
The instrument has the ability to switch automatically between its two references.
This allows using the caliper for both internal and external measuring without
going through the menu to change the reference.
Steps :
On Ref 1
•
Introduce a measurement standard as preset, measure this standard and
do a preset recall
•
Or set the zero at closed jaws position
On Ref 2
•
Measure the internal measurement probes gap (with a caliper, probes
included) and introduce it as preset value
•
Do a preset recall at closed jaws position
Set AREF
It is now possible to measure in REF1 when closing the jaws or in REF2 when
opening the jaws.
4. Advanced functions
Prolonged pressure (>2s) on
Then, each short press on
MODE
MODE
MODE
MODE
gives access to the advanced functions.
MODE
accesses the required function :
MODE
SET
................. Tolerance display
................. Choice of measurement direction
SET
7
SET
MINIMUM, MAXIMUM mea-
surement and DELTA (TIR)
(inputting tolerance limits, see chap. 6)
(positive or negative sense)
E